Atmel AT85DVK-07 - Manual (Page 10)

Operating Modes
3-8 AT85DVK-07 Demonstration Firmware User’s Manual
7687C–MP3–09/07
3.2 Player The easiest way to play the Nand Flash disk is to select the player operating mode.
From the main menu, select the player icon, then confirm by pressing the Select key.
The player will automatically start playback of all songs in the Nand Flash and MMC (if
present) disks or from the last saved position (file + played time) if file still exists.
If the MP3 file contains ID3 tags, they are automatically displayed.
3.2.1 Player Status The player status can take the following states:
3.2.1.1 Playing Control To toggle Play and Pause mode:
• Press the Select key briefly.
To Stop the player:
• Press the Select key and keep it pressed (long press).
3.2.1.2 Song Selection To skip the current played song:
• Press the Right Key briefly to play to the next song.
• Press the Left Key briefly to skip to the previous song.
3.2.1.3 Fast Forward
Fast Rewind
To quickly go forward or backward inside the audio stream:
• Press the Right key and keep it pressed to enter fast forward play mode.
• Press the Left key and keep it pressed to enter fast rewind play mode.
3.2.1.4 Repeat AB To setup a repeat AB sequence, perform the following key sequence:
• Press the F1 key to set the A marker
• Press the F1 key again to set the B marker and restart play back to the A marker
• Press the F1 key again to cancel the repeat sequence
3.2.1.5 Volume Control To increase or decrease the audio volume:
• Press the Vol-Up key or Up key to increase the volume.
• Press the Vol-Down or Down key to decrease the volume.
A pop-up windows appears which gives information on volume level:
File Name
ID3 Song Name
ID3 Singer Name
Stream Type
Index/Total song
Player Status
Play Time
Stream Bit-Rate
in current directory
Play
Pause
Stop
Fast Forward
Fast Rewind
Play A TAG Set
Repeat AB Sequence