Rubbermaid 9VWD16 User Manual
Page 6
Assembly
(cont.)
16
E
1
2
18
C
B
1
2
19
B
D
V
(Complete view of assembled cart frame.)
Attach bumper to cart frame. Align posts and tabs to secure
bumper.
Place inner tank into outer tank. Ensure tab aligns with notch
in outer tank. Slide small foam filter onto standpipe. Ensure
top of small foam filter and top of standpipe are flush.
Place float ball onto seal. Snap small float cage onto bottom of
inner tank.
20
A
Y
X
Ensure HEPA filter/HEPA foam sleeve are fully seated on
powerhead. Turn powerhead right side up.
10
21
1
2
A
22
L
Place powerhead onto outer tank. Ensure tabs on front of
outer tank align with notches on front of powerhead. Rotate
latches on each side to secure powerhead.
Slide caddy past spring loaded buttons and onto diagonal
supports.
11
ENGLISH
15
1
2
2
H
H
3
14
1
2
T
S
Turn cart sideways onto hard surface. Place remaining wheel
onto axle. While holding cap nut with needle nose pliers, tap
cap nut onto axle with hammer.
Lay cart back. Insert casters into caster brackets. Ensure
casters are fully inserted.
Notice: Cap nuts cannot be
removed without causing damage
to cap nuts and axle.
Place outer tank onto cart frame. Align drain cap with notch in
axle support. Tighten tank release knob.
2
17
1
D
1
13
R
T
Insert axle through wheel. Then insert axle into axle support.