Speedtech 67-69 Camaro T56 Crossmember - Manual (Page 3)

3 | P a g e
1. Assemble the Stainless adjusters to the frame plates (2,5). Use Antiseize on
all bolts.
2. With the old transmission crossmember removed and your T56 held in place
with a tranny jack, install the right and left side frame mount plates (1,3) on
top side of the frame rail. These frame mounts go on specific sides and are
marked accordingly. If it is too tight to fit the brackets in place you may need
new body mounts. Only hand tighten them at this time.
3. With Antiseize on the bolts, install crossbar to the side plates and slide the bar
forward or back until it lines up with the transmission mount (Speedtech part #
220531 or Energy Suspension # 3-1108G).