Speedtech Lower Control Arm User Manual
Page 4
4 |
P a g e
Install new sway bar end links according
to diagram at right.
10. If using factory disc brakes you may need to clearance the dust shield
slightly. With the assembly supported by the floor jack, turn the steering wheel
lock to lock and have a partner check for any interference. Trim dust shield as
necessary.
11. Grease control arm bushings and new ball joint. Grease other suspension
components as needed. We recommend silicon based grease, however any high
quality grease will do. Reinstall wheel, torque to recommended specs.
12. Repeat process for other side of car.
13. Once all parts are reinstalled, push down on the bumper a few times to settle
the suspension to normal ride height. With the car supported on the tires, torque
the lower control arm bolts to 50 ft/lbs.
14. Do not drive the vehicle, have it towed to a competent professional alignment
shop to have an alignment performed.
Note: Use alignment specifications on next page, not alignment shop
pre-programmed factory specs!