Antec HCP-1200 - Manual (Page 6)

I NSTALLATION :
1. Install the HCP-1200 PSU into either the top or bottom of
your case manual if you are unsure where the power supply should be installed.
2.
Install the HCP-1200 PSU into your case with the four screws provided.
3.
Connect the 24-pin main power connector to your motherboard. If your motherboard uses a 20
connector, detach the 4-pin attachment on the 24
Note: The detachable 4-pin section cannot be used in place of a 4
4.
Connect the 8-pin or 4+4-pin connector for the CPU. If your motherboard has an 8
some of the openings, we recommend that you remove the cover and use the 8
Note: Please also refer to your motherboard
either the top or bottom of your case with the four screws provided.
your case manual if you are unsure where the power supply should be installed.
PSU into your case with the four screws provided.
pin main power connector to your motherboard. If your motherboard uses a 20
pin attachment on the 24-pin connector.
pin section cannot be used in place of a 4-pin +12V connector.
pin connector for the CPU. If your motherboard has an 8-pin socket with a cover on
some of the openings, we recommend that you remove the cover and use the 8-pin connector.
Please also refer to your motherboard user’s manual for any special instructions.
your case with the four screws provided. Refer to
pin main power connector to your motherboard. If your motherboard uses a 20-pin
pin socket with a cover on
pin connector.