Symetrix xControl - Manual (Page 3)

Basic Hookup
QUICK START GUIDE: SymNet xControl
3
PRIMARY SECONDARY
DANTE NETWORK AUDIO
ARC-2e
DOWN
UP
MENU
ARC ETHERNET
The RJ45 connectors labeled “ARC” are only for use with the ARC ser ies of remotes.
DO NOT plug the ARC connectors on Symetrix products into any RJ45 connector labeled “DANTE”, or “ETHERNET” .
The “ARC” RJ45 connectors on Symetrix products can carr y anywhere from 6 to 24 VDC which can damage Dante and Ether net circuitr y.
Configuring IP Parameters
Locating Hardware
Discovery of, and connection to, xControl hardware is done
with the Locate Hardware dialog found under the Hardware
menu or by clicking the Connection Status box in the bottom
left corner of the xControl icon.
The Locate Hardware dialog will scan the network and list available units with DHCP IP addresses. Select the xControl unit to assign a static
IP address to and click the Properties button. To assign the xControl a static IP address, select “Use the following IP address” and enter the
appropriate IP Address, Subnet mask and Gateway. Click OK when finished. Next, back in the locate hardware dialog, ensure the xControl
device is highlighted and click “Select Hardware Unit” to connect the selected xControl on the network to the xControl in the SymNet
Composer Site File. Close the Locate Hardware dialog.
- Or -
- Or -
IP Configuration with Composer
Direct connection to DSP
using PoE injector.
Connection to non-PoE
switch/network using
PoE injector.
Connection to PoE
switch/network without
PoE injector.
Powering and Hookup to the Network