Telenav for Nextel Supported Devices: v2.2.5 for Motorola i830 User Manual
Page 30
© TELENAV 2003-5
PAGE 30 OF 39
Address entry from the phone
To enter a new address you need to first select New address. Next you can select one of the recently
entered cities, or an airport; and you can also enter the new address using a City/State combination, or
a ZIP code followed by entering the numbered street address or the crossing street names.
Voice Call
If you select Voice call, your phone will go into voice call mode with the Voice Address Input System
number displayed on the screen. Press the green button to dial the number, and dictate your address
as described above. When you are done with the call, press BACK, the Menu key, highlight Java
Apps, press OK, highlight Suspended Apps, press the OK key, highlight TeleNav 2.2, and press the
OK key again. At this point, TeleNav will resume, and automatically Refresh list so that the called in
address appears on your phone. Highlight the newly entered address, and press OK.
New City/State
If you select New city/state, you will be taken to the State entry page. Here you first enter the US
Postal Service state abbreviation e.g., “CA” for California. First, you will have to press Menu, highlight
Alpha mode, and press Select because it is hard to enter USPS prefixes in Word mode.
Enter State (2 ltrs)
State
OK BACK
After you enter the state USPS code, you will be asked to enter the city name. You may want to
change from Word to Alpha mode first if the name you are trying to enter is not likely to be part of a
commonly used word
3
. Only the first three (or more) characters are needed to enter the city name. For
example if you were trying to enter “Sunnyvale” as the destination city, you would enter sun using
Alpha mode. Using Word mode will result in run if you press 786. On the other hand, if you wanted
“Santa Clara”, Word mode does produce santa if you press 72682.
Hint: Use the “*
←” key at the lower left corner of the keypad to backspace and remove incorrectly
entered letters. Also note that some keys are marked with alternative characters that they will produce
after several key presses. Pressing the 1 key in alpha or Word mode produces a spectrum of
punctuation, most of which is not needed for address input.
3
Press MENU, and select an alternative data entry mode to leave WORD mode.