Turbo Action 70250 Command Center - Manual

Part #70250 1 1/89,10/99
COMMAND CENTER for CHEETAH SCS SHIFTER
1535 Owens Road, Jacksonville, FL 32218
Phone 904-741-4850 * Fax 904-741-4853
Part #70250
Installation Instructions
Kit Includes: 1 - 70087 Decal, Start;Ign;Fuel;Fuel
1 - 70088 Decal, Fan;Pump;Lights;Aux
2 - 70089 Decals, Turbo Action Command Center (Installed)
1 - 70153 Bushing, 5/8 to 15/32
4 - 70159 Screws, Truss 1/4 - 20 X 1/2
1 - 70258 Cover, Plastic
7 - 00775 Switches, Toggle (30 Amp)
1 - 00778 Switch, Push to Start (35 Amp)
Turbo Action, Inc., a supplier of Hi-Performance Automatic Transmissions, Shifters and Converters, thanks you for
your purchase of the Turbo Action Command Center. The Turbo Action Command Center provides a handsome
cover for the revolutionary Turbo Action CHEETAH SCS Shifter, but more important it brings all major functions of
the vehicle to within easy driver reach. The Turbo Action Command Center is a major breakthrough in safety by
providing fingertip control to functions such as starter, ignition, fuel pumps, fan, lights, etc. No more loose safety
belts or harness. All switches are heavy duty and have high current carrying capabilities. The light weight cover
with factory switches provides function, safety, easy accessibility for service and a hi-tech look for the vehicle’s
interior. The Turbo Action Command Center will fit all models of the CHEETAH SCS Shifter.
STEP #1: The Command Center can be used with Chrysler, Ford or G.M. CHEETAH SCS Shifters.
STEP #2: Note that both sides of cover has three small holes and one large hole. The one large hole is for the
Push to Start Start Switch, the other large hole you will insert bushing provided and then install the
toggle switch. Figure #1 shows an example of bushing inserted on the inside of cover with toggle
switch in place.
STEP #3: We recommend installing the Push to Start Switch on the driver’s side. See Fig. #2 for G.M. and Ford
shifter. See Fig. #3 for Chrysler shifter.
STEP #4: Carefully install decals on appropriate sides of cover.
STEP #5: Install nuts on toggle switches.
STEP #6: Install bushing in hole that will be the Aux. position on decal. Note the bushing installs from the
underside of cover. See Fig. #1.
STEP #7: Install the toggle switch into the hole with the bushing.
Important: All toggle switches should be installed with the off towards the outside of the shifter.
See Fig. #4.
STEP #8: Install three more toggle switches on the Aux. side.