Tuff Country 33910 - Dodge 94-01 Ram 1500 3 kit - Manual (Page 3)

Poly bushing bag D3IPL includes:
Description
Quantity
PB2408 (poly bushings)
16
Sleeve bag D3ISL includes:
Description
Quantity
S10029 (.875" X .500" X 2.250")
4
S10030 (.875” X .560” X 2.625”) 4
Sleeve bag D5ISL includes:
Description
Quantity
S10042 (.875" X .563" X 2.250")
4
S10043 (.875" X .693" X 2.760") 4
Hardware bag D3INB includes:
Description
Quantity
3/8” x 1 1/2” bolts 4
7/16” USS flat washers 4
5/16” USS flat washers 10
1/2” x 1 1/2” bolts 2
3/8” fender washer 4
3/8” nylon insert nut 6
1/2” unitorque nut 2
Special note: Before installation begins, it is the
customers/installers responsibility to make sure that
all parts are on hand. If any parts are missing, please
feel free to call one of our customer service
representatives @ (801) 280-2777.
Tuff Country EZ-Ride Suspension highly
recommends that the customer or the installer
checks to make sure that all parts are on hand before
the installation begins. If any parts are missing,
please feel free to call one of our customer service
representatives @ (801) 280-2777.
Torque Settings
5/16” 15—18 ft lbs.
3/8” 28—32 ft lbs.
7/16” 30—35 ft lbs.
1/2” 65—85 ft lbs.
9/16” 85—120 ft lbs.
5/8” 95—130 ft lbs.
3/4” 100—140 ft lbs.
Please follow instructions carefully:
Before installation begins, measure from the center
of the hub, to the bottom of the fender well, and
record measurements below.
Pre-Installation measurements:
Driver Side Front:______________________________
Passenger Side Front:__________________________
Driver Side Rear:______________________________
Passenger Side Rear:__________________________
At the end of the installation, take the same
measurements and compare to the pre-installation
measurements.
Post-Installation measurements:
Driver Side Front:______________________________
Passenger Side Front:__________________________
Driver Side Rear:______________________________
Passenger Side Rear:__________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle
so that the vehicle is stable and can’t roll backwards.
Safely lift the front of the vehicle, and support the frame
with a pair of jack stands. Place a jack stand on both the
driver and passenger side. Next, remove the tires and
wheels from both sides.
2. Position a pair of hydraulic floor jacks under the front
axle. Place one jack stand on the driver side and one on
the passenger side. Carefully raise up on both hydraulic
floor jacks at the same time until they make contact with
the front axle.
3. Working on the driver side, un-bolt the stock sway bar
at the frame location and save the stock hardware for
later re-installation. Repeat procedure on passenger side.
Let the stock sway bar hang.
4. Working on the passenger side, remove the stock
hardware that connects the stock track bar to the stock
location. Save the stock hardware for later re-installation.
5. Working on the driver side lower control arm axle
mount, scribe a mark on the stock alignment cams and
reinforcement bracket. This mark will be used as a
reference when installing the new front lower control
arms. Repeat procedure on the passenger side.
Illustration # 1
6. Working on the driver side, scribe a mark on the stock
coil spring and another directly across on the stock lower
coil spring pocket. Special note: scribe the mark on the
bottom of the stock coil spring and one directly