Tuff Country 54910 - Toyota Tacoma 05-14 4 uni-ball lift kit - Manual (Page 8)

27. Re-install the tires and wheels and torque the lug nuts to
the proper torque specifications.
Front Installation complete!
Rear end installation:
28. To begin installation, block the front tires of the vehicle
so that the vehicle is stable and cannot roll. Safely lift the
rear of the vehicle and support the frame with jack stands.
Make sure the parking brake is NOT set, then remove the
tires and wheels.
29. Working on the driver side, remove the shock from its
upper and lower mounts. Repeat on passenger side. New
longer shocks are highly recommended once part num-
ber 54910 has been installed on your vehicle, and the
rear shocks may need to be ordered as a seperate part
#. If you have not already ordered your shocks, please
feel free to contact Tuff Country or your local Tuff
Country dealer and order shocks. Tuff Country recom-
mends installing a 26” fully extended shock in the rear.
30. Working on the driver side, remove the brakeline bracket
from the axle housing, the bolt may be discarded
31. Position a pair of hydraulic floor jacks under the rear
axle, raise up on both jacks until they make contact with the
rear axle, working on the passenger side, loosen but don’t
remove the ubolts, now move to the driver side and remove
the ubolts completely. Lower down the driver side of the axle
enough to install new rear block. Place new rear block in
between the bottom of the leaf springs and the axle perch.
Raise jack and install new longer ubolts loosly. Now move
back to the passenger side and repeat procedure. Once
both blocks have been installed, Torque the new ubolts to
85 ft lbs.
32. Locate (1) S10105, (1) 8mm x 50mm bolt, and (1) 8mm
flat washer from hardware bag 54910NB. Install new spacer
sleeve between the brakeline bracket and the axle mount.
Torque bolt to
12 ft lbs.
33. Locate new shocks and install into OE location using OE
Lower hardware.
34. Re-install the tires and wheels and torque the lug nuts
to the proper torque specifications. Carefully remove vehicls
from any jack stands.
Installation Complete!
Check and double check to make sure that all steps
were performed properly. After the completion of this
install, Tuff Country Recommends taking the vehicle in
for a complete front end alignment.
Tuff Country EZ-Ride Suspension recommends that a
complete re-torque is done on all bolts associated with
this suspension system. It is the customers responsi-
bility to make sure that a re-torque is performed on all
hardware associated with the system after the first 100
miles of installion. It is also the Customers responsibil-
ity to do a complete re-torque after every 3,000 miles or
after every off road use. Neglect of following these steps
could cause brackets to come loose and cause serious
damage to the suspension system and to the vehicle.