Yetter 2960-126 Universal Spring Kit - Manual (Page 7)

7
HEAVY DUTY COULTER INSTALLATION
NOTE: Mounting hardware included in 2960-122 bolt bag.
1. Mount the universal unit coulter bracket to planter breast plate using three ½” x 1 ½” bolts, washers
and locknuts. Use the ¼” thick washer on the lower large slot, do not tighten fully yet.
NOTE: The 9/16” dia. round hole is not used on this application, disregard this hole.
2. Mount unit coulter arm to unit coulter bracket using ½” x 2 ½” bolt, flat washers and locknut through
slots in bracket and upper hole in the arm and ½” x 2” bolt and locknut through desired lower holes
of bracket and arm.
3. Install blade on hub using four ½” x 1 1/4” carriage bolts, lock washers and nuts.
4. Align coulter blade with opener blades by sliding bracket on breast plate, then tighten the bolts
securing the bracket to the planter unit.
5. Adjust coulter depth as required. Please note that the minimum depth setting of this coulter on
the Deere 7200 and 1700 series planters is even with the opener discs. As the blade wears,
the coulter may be adjusted to compensate.