Yetter 2967-014 TITAN Series Narrow Row Short U.N.T. Residue Manager - Manual (Page 10)

10
OPERATION
CAUTION: Where rocks are present the residue manager should be set in the “float” position,
not locked down.
Adjust the residue manager to move crop residue aside and not move any soil. Adjustments to the residue manager may
have to be made when changing field conditions and type and amount of residue. Use the handle for leverage when
changing depth settings.
“FLOAT SETTINGS”
Install the adjustment pin below the combo arm.
To raise the wheels, lift the combo arm and move the adjustment pin up.
To lower the wheels, move the adjustment pin down.
“RIGID SETTING”
Install the adjustment pin through the combo arm.
To raise the wheels, lift the combo arm to the desired position and insert the pin.
To lower the wheels, lower the combo arm to the desired position and insert the pin.
ROW CLEANER DO’S AND DON’TS
1. DO NOT move soil; Residue Managers are designed to move crop residue only.
2. DO NOT operate planter at slow speeds, ground speed affects how aggressive the spoke
wheels are; operate at sufficient speed (4-6 mph) to maintain good residue flow.
3. DO NOT expect 100% of crop residue to be cleared, it is not necessary and would necessitate
engaging the soil. The width of path cleared depends on ground conditions, depth setting and
ground speed.
4. DO expect to see wheels occasionally quit turning, indicates ideal (shallow) setting which is
not moving soil.
5. DO adjust toolbar frame height 20”-22” and drawbar to “level” correctly. Very important to
ensure planter opener will follow ground contours properly.