Yetter Systems One Seed Partner - Manual (Page 8)

8
GENERAL INFORMATION
POWER UNIT SET UP
NOTE: Gasoline, oil, and a 12-Volt Battery (Group 58 or 26-70) will be required before the unit
can be operated.
DO NOT START ENGINE OR USE BLOWER BEFORE FILLING WITH PROPER
LUBRICANTS. ENGINE HAS AN OIL LEVEL SENSOR; OIL LEVEL MUST BE FULL ON
DIPSTICK. DO NOT OVERFILL!!
WARNING: Read and follow all safety procedures described in instructions provided
by engine and blower manufacturers before attempting to operate this unit.
1. Fill crankcase of engine with oil as specified in the instructions supplied by the engine manufacturer. (High
quality SAE 30 weight, SE, SF or SG service grade)
2. Fill gasoline tank with clean, fresh lead free gasoline (85 octane), refer to engine instruction book for specific
details.
NOTE: Briggs & Stratton does not recommend the use of gasoline which contains alcohol such
as gasohol. If gasoline with alcohol is used, it must not contain more than 10% Ethanol and
MUST be removed from the engine during storage. DO NOT use gasoline containing methanol.
3. Add oil to blower gear case as explained in blower operating manual. DO NOT OVERFILL.
4. Install and clamp securely a 12-Volt battery, Group 58 or 26-70.
5. Check that all electrical connections are tight.
6. Check tension of drive belt.
7. Ensure that all safety shields are in place.
NOTE: For questions concerning warranty on the engine or blower, contact the corresponding
manufacturer or the local service/retail outlet.