Avanti PIM 25 SS - Manual (Page 9)

9
OPERATING YOUR ICE MAKER
 Control Panel Description
Start
Press to start the ice making cycle.
Stop
Press to stop the ice making cycle.
Ice Size
ICE SIZE SELECTION of (S) small, (M) medium or (L) large.
The default cube size from the factory is set at SMALL.
Each time you press this button the cube size selection will change 1 size (Small, Medium, Large)
in sequence.
The chosen mode shall stay as selected unless changed or there is a power failure.
For the most efficient operation when ambient temperature is below 15°C (59ºF) use the small
cube size setting.
LED INDICATORS
ICE SIZE INDICATOR (GREEN) (S) small, (M) medium or (L) large.
The indicator below the selected cube size will be illuminated green.
ADD WATER INDICATOR (RED).
The ice maker automatically checks the water level in the tank. If the water level is too
low the indicator will illuminate in RED and will stop working automatically. Once you add
water to the unit the indicator will turn off and will resume normal operation.
ICE FULL INDICATOR (RED).
When the ice-bin is full, the indicator will illuminate in RED. The indicator will remain lit
until the ice in the bin either melts away slowly or has been removed. The unit will stay in
a “Standby” mode until the ice has been removed / melted at which time the unit will
automatically start operation as normal.