C-TECH-I Imperiale LI-VLK-2 - Manual (Page 2)

C-TECH-I, INC
USERS' GUIDE
Installation
See the illustration left
1. Position the faucet body at
the hole of the sink.
2. From the bottom, assemble
the decorative ring, nuts,
rubber gasket, steel gasket,
bolts and nuts. Tighten
them with a wrench. Fix the
faucet body up to the sink
appropriately.
3. Revolve one end of the
cold and hot inlet hoses
into the faucet body; and
the other end connect to
the cold and hot water
supply. Do not use
excessive force
the three points
1) Flush the pipe;
4. Connect the inlet hoses to
the water supplies. Before
connecting the inlet hose to
the indoor water supply
pipe, you should pay
attention to
as follow:
Max 860kpa(8.6bar)
Hot
Cold
2) There are no stings at the ends of the water supply pipe;
3) Using other seal materials at the ends of the inlet pipe is not allowed
2