DAVIS Radiation Shield (7714) - Manual (Page 11)

9
2. Place a #8 flat washer over the end of each of the #8 x 2 3/4” pan head screws.
As long as the extra length of screw end protruding from the bottom of the
radiation shield doesn’t create clearance problems when mounting the
radiation shield, you can use the #8 x 2 3/4” pan head screws. If a clearance
problem exists, you will need to use #8 x 1” screws instead (not included).
3. Slide the three #8 x 2 3/4” pan head screws (with washers) up through the
holes you just drilled.
4. At this point, you may want to place a small piece of tape over each of the
screw heads to keep the screws in place as you continue.
5. Place a 1/2” spacer over each of the screw ends protruding from the closed
plate.
6. Slide the mounting bracket over the screw ends protruding from the closed
plate.
7. Secure the mounting bracket to the closed plate using a #8 flat washer, a #8
split lock washer, and a #8 hex nut on each of the screw ends.
Tighten until the mounting bracket is firmly attached to the closed plate.
Closed
Plate
1/2" Spacer
#8 x 2-3/4" Screw
#8 Hex Nut
#8 Lock Washer
#8 Flat Washer
#8 Flat Washer