DAVIS Leaf Wetness Sensor for Vantage Pro2 - Manual (Page 3)

3
T
ESTING THE
S
ENSOR
You may test the sensor before or after you mount it.
1. Connect the sensor.
2. Make sure you are getting a leaf wetness reading on the console.
Consult the Vantage Pro2 Console manual for instructions.
3. Drop or spray water onto the sensor and make sure the reading changes.
M
OUNTING THE
S
ENSOR
Mounting the Sensor On a Wooden Surface
Use the #8 wood screws to mount the sensor on a wooden surface as shown.
Mounting the Sensor on a Pipe
To mount the sensor on a pipe, stake, or pole with outside diameter between
1"
and 1-1/4" (25 mm and 31 mm), secure the sensor to the pipe using the 1-1/2"
U-bolts, 1/4" flat washers, and 1/4" hex nuts as shown below. Use a 7/16"
wrench or adjustable wrench to tighten the hex nuts.
Solar Panel