DAVIS DriveRight Remote Download Kit Manual (8188) - Manual (Page 6)

4
5. Test the connection.
In the HyperTerminal window, type (in ALL CAPS as shown)
A T
and press Enter. If “OK” appears in the window, you are com-
municating with the field modem (go on to “Pre-Programming
the Field Modem” on page 4).
If you do not get an OK, type
A T E 1 V 1 Q
and press Enter. Then type
A T
again and press Enter. You should be able see the “AT” as you
type it, and you should receive an OK back. (If you receive an
OK, go on to “Pre-Programming the Field Modem” on page 4.)
If you do not receive an OK, check all your connections and try
again. If you still have no success, try switching to a different
serial port (see step 5 on page 3).
Pre-Programming the Field Modem
Once the HyperTerminal connection is secure, you are ready to pre-
program the field modem. To set the modem to automatically down-
load when turned on, follow the steps below. You should receive an
OK after each entered command, unless stated otherwise.
1. Set autodial capability.
To configure the modem to automatically dial when switched
on, type
A T S 1 3 = 1 6
and press Enter.
2. Set the phone number for automatic dialing.
To set the phone number of the host computer, type
A T & Z 0 = 2 0 2 - 5 5 5 - 0 4 5 5
where “0” is zero and “202-555-0455” is the number of the host
computer. Then press Enter.
Remote Dowload Manual D006.fm Page 4 Thursday, April 17, 2003 8:08 AM