Monoprice 5921 Wall Mount Bracket - Manual (Page 8)

8 of 8
• Do not remove or loosen screw while the mount is in use. Doing so may cause the screen to fall.
WARNING
Note: Make sure cords have enough slack to allow
full movement of the arm. Route cords inside
F
arm slots of wall arm assembly (AA) as shown
in fig.F.1. For demonstration purposes, the wall
has been omitted from the image.
Cable Management
Adjust tension knob on side of mount as shown in fig.
E.1 to desired tension to balance your screen size
and weight.
The tension knob, without changing the bracket tension,
can be pulled out, away from the bracket and turned
independently of the knob post for readjustment as
shown in
fig.E.2.
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of -5° forward or +15°backward
.
E
• Be careful not to pinch fingers when opening and
closing mount from the wall.
CAUTION
fig.F.1
fig. E.1
fig. E.2