Monoprice 6517 Wall Mount Bracket - Manual (Page 7)

7 of 8
top screw
Attach Assembly Adapter Plate to Assembly Arm
1. Insert two M8x15mm screws
and two metal washers into swivel box
on Assembly Adapter Plate as above
shown.
Leave approx. 1/4" of exposed thread.
NOTE:This procedure will require
two persons.Ensure that the arm is
set to its maximum negative tilt prior
to attaching the display
2. Lift the display and hook it
over the mounting head by lowering
the exposed portion of the top screws
down the open key slots.
3. Once in position, attach the bottom
two M8x15mm screws and two
washers to secure the display to the
mounting head using M5mm Allen
Wrench.
.25"
Iron spacer
M8x15mm
A
G
screw bolt
For Flat Back Screen
SCREEN
SPACER
SCREEN
fig C.1 fig C.2
SCREW
AA(mount)
OR
Select the small,medium,large or extra large screws from the screw package .Fastener pack then
attach screen brackets(AA) to screen following figure C.1 or C.2 on page 7.
SCREW
AA(mount)