Dee Zee DZ16251 - Manual (Page 6)

Page 6 of 8
DZ 16251 04/15/09
Place bracket (B) in between the front legs of bracket (D). on the side opposite the tab on
bracket (B), place bracket (E) and using 8mm x 25mm Hex Head bolt (K) and 8mm hex nuts (L)
in 4 locations secure the brackets by tightening, but do not tighten completely. Then insert
the 8mm x 25mm Hex Head bolt (K) through the bracket tabs as shown below and secure on
the top side with M8 – 1.25 single tab weld nuts (J). Place bracket assembly in front driver
location and using two 8mm x 25mm Hex Head bolts (K) replace the two bolts you removed in
step 1 using the center 2 slots in the bracket (D). Tighten all fasteners in position, but do not
tighten completely.
3
E
B
D
J
13 mm
K
K
L