Dee Zee DZ1532 - Manual (Page 10)

Drill 1/4" holes up through the slots into the board at the locations shown below.
Attach the running board to the angle brace using the hex head bolt [G],
14
13
Attach the running board to the angle brace using the hex head bolt [G],
1/4" flat washer [H], and 1/4" hex nut [I]. Tighten using a 7/16" wrench and socket.
Check all hardware to make sure it has been tightened.
Repeat the assembly steps for the other side of the vehicle.
14
DZ 1532 8 OF 8 7/28/2011