Dee Zee DZ2545 - Manual (Page 9)

Drill 1/4" holes up through the slots into the board at the locations shown below.
Attach the running board to the angle brace using the hex head bolt [G],
10
9
Attach the running board to the angle brace using the hex head bolt [G],
1/4" flat washer [H], and 1/4" hex nut [I]. Tighten using a 7/16" wrench and socket.
Check all hardware to make sure it has been tightened.
Repeat the assembly steps for the other side of the vehicle.
10
DZ 2545 7 OF 7 10/14/2011