Dee Zee DZ1361 - Manual (Page 4)

WRENCH/RATCHET
3/8", 7/16",
TAPE
13mm, 18mm MEASURE
TIN SNIPS
3/16" DRILL BIT
PHILLIPS SCREWDRIVER
Using tin snips, cut a piece of rubber trim [B] 31" long.
Place the rubber trim onto the back lip of the running board starting at the notch
at the rear of the running board. The gasket will not run the entire length of the board to allow
clearance with the underside of the truck box.
TOOLS REQUIRED
1
DZ 1361 2 OF 9 5/23/2011