Dee Zee FX12358 - Manual (Page 5)

Place the end cap [D] onto the running board as shown below. The image shown is the drivers side
side box board. Secure the end cap in place using a phillips head screwdriver and
two 1/4 x 1" black phillips head round head screws [M].
Place the mud flap [C] onto the running board as shown below. The image shown is the drivers side
2
3
Place the mud flap [C] onto the running board as shown below. The image shown is the drivers side
side box board. Secure the mud flap in place using a 3/8" socket or wrench and
one black sheet metal screw [K]. Holding the end cap against the running board to minimize the
gap on the top surface, drill a 1/8" hole through the end cap and board on the bottom side .
Attached the end cap with a sheet metal screw [L].
3
FX 12958 3 OF 17 6/1/2011