Outback Power Systems GS Load Center Installation Manual - Manual (Page 24)

Installation
22 900-0123-01-00 Rev B
Mounting the HUB Communications Manager
The GSLC provides mounting holes to support a HUB Communications Manager.
Figure 22 Mounting the HUB to the GSLC Enclosure
To mount the HUB Communications Manager to the side of the GSLC enclosure:
1. Locate the mounting holes on the side of the GSLC enclosure as shown in Figure 8 on
page 10.
2. Remove the knockouts and add bushings.
3. Align the HUB (vertically) over the mounting holes with the HUB’s ports facing forward.
4. Insert the mounting screws from the outside into the GSLC enclosure. The mounting
screws are provided with the HUB.
5. Tighten until secure, but do not over-tighten.
6. Install CAT5 cabling as needed.
7. Install the protective shield for the HUB.
Mounting
Screw
Mounting
Screw