Installing the flexware 50 – Outback Power Systems FLEXware 250 - Users Guide User Manual
Page 11
Installing the FLEXware 50
With the FX secured to a surface (see FX Series Inverter/Charger Installation Manual for details),
the FLEXware 250 installs on either the DC or the AC side of the FX.
To install the FLEXware 50:
• Remove the cover plate screws and cover plate.
• Verify which knockouts will be removed for the installation and remove those knockouts.
• Remove only the two M5 X 12mm screws that secure the FX’s upper and lower casing
halves on whichever side (AC or DC) you first install the FLEXware 250.
• Insert the unthreaded standoffs into the holes on the FX and then insert two M5 X 25mm
screws, included with the FLEXware 250, into the standoffs and tighten.
• After all wiring has been completed, install the DCC and securing with four M5 X 12mm
screws (included with the DCC).
• Install each FLEXware 250 top cover plate and secure the #10 X 3/8” sheet metal screws.
For AC wiring instructions for the FLEXware 250, please see the schematics in the individual
AC Input/Output/Bypass Assembly (IOB) kits.
Figure 8: FLEXware 250 Dimensions