Outback Power Systems HUB10.3 - Quick Start Guide - Manual

Quick Start Guide
900-0154-01-00 REV B.vsd\2014-02-18
©2013 OutBack Power Technologies. All Rights Reserved.
HUB 10.3
Contact Technical Support:
Telephone:
+1.360.618.4363
Email: [email protected]
Website: www.outbackpower.com
IMPORTANT:
Not intended for use with
life support equipment.
OutBack Power and the OutBack Power logo are trademarks owned and used by
OutBack Power Technologies, Inc. The ALPHA logo and the phrase “member of
the Alpha Group” are trademarks owned and used by Alpha Technologies.
These trademarks may be registered in the United States and other countries.
A Positions
3.
Changing Jumpers
2.
4a.
4b.
1.27"
(3.2 cm)
10.63" (27 cm)
6.18"
(15.7 cm)
4.23"
(10.7 cm)
9.24" (23.5 cm)
Dimensions
Mounting
#10 x ½” Screws x 2
HUB10.3 HUB Wiring Cover
Cable, CAT5e, 3' (1 m) x 2
Cable, CAT5e, 6' (2 m) x 3
Parts List
Cable, CAT5e, 10' (3 m) x 4
Shutter Bushing x 2
Snap Bushing x 2
2.
1.
3.
1" recommended
1. Back of HUB 10.3
4c.
B Positions
Used for three-phase OutBack stacking with
FX, VFX, FX(E) or VFX(E) inverters.
For these applications, place only two jumpers
in the positions noted in the photograph
and the diagram.
Remove all remaining jumpers. No others are
used for this configuration.
Searching for Devices
Found
HUB10.3 Sub-phase Master
Jumper position identified by
MATE3 on power-up:
Searching for Devices
Found
HUB10.3
Used for Subphase Master stacking in FX
and GS inverters (both three-phase and
series configurations).
For these applications, place all jumpers
in the positions noted in the photograph
and the diagram.
NOTE: This option requires MATE3
firmware revision 002.013.000 or higher.
Jumper position identified by
MATE3 on power-up:
Searching for Devices
Found
HUB10.3
Jumper position identified by
MATE3 on power-up: This is the factory-installed initial position.
Used for classic series, OutBack series, and
parallel stacking. Also used for three-phase
OutBack stacking with models GVFX(E) and
GTFX(E) .
For these applications, place all jumpers in
the positions noted in the photograph and
the diagram.