Audiovox GMRS200W - Manual (Page 9)

128-6781
9 of 16
Operating Modes and Features
GRMS/FRS Operation
- From GMRS/FRS standby mode, press and hold the power
button for 2 seconds to turn on power.
- Press the Function (F) button so the Channel number flashes.
- Select the desired channel with the Up (10) and Down (11)
Buttons. When receiving a call, the RX icon on the LCD ap-
pears to indicate incoming received signal.
- Press and hold the PTT button (3) to transmit, then speak into
the microphone clearly and slowly.
- Communication can only be accomplished when the channel
frequency of at least two parties are the same.
- Release PTT Button (3) to receive.
Channel Selection
In order to communicate with other GMRS/FRS units, both
transmitting and receiving party must be on the same frequency.
The GMRS200W has 22 channels (frequencies) (1-22) indicated
by the large digits on the LCD display panel. Channels 1 through
7 are the shared GMRS/FRS channels. Channels 8-14 are FRS
only channels, while channels 15-22 are GMRS only channels.
Communication with Audiovox GMRS/FRS and compatible units
is possible on these 22 channels.
To change the channel:
- From GMRS/FRS standby mode, press the Function (F) but-
ton (6) until the channel number flashes.
- Press the Up Button (10) briefly to move to the next higher
main channel number.
- Press the Down Button (11) briefly to move to the next lower
main channel number.
9