Pure ONE Classic Series 2 - Manual (Page 17)

13
Using a ChargePAK
ChargePAK C6L is a high powered rechargeable battery pack. ChargePAK provides the benefits
of rechargeable batteries without the inconvenience of removing and recharging separate
batteries. ChargePAK is designed to be left in your unit, so if usually connected to the mains,
your product will always be charged up, ready to go.
Installing ChargePAK
1. Switch your radio off and
disconnect from the mains power
supply.
2. Open the battery compartment
and push the ChargePAK
connector plug into the socket
in the compartment. Line up the
ridges on the plug with the slots
in the socket to ensure correct
orientation. Do not force the plug.
3. Insert ChargePAK into the battery
compartment, logo side out.
4. Replace the battery cover
and connect your product to a
power supply.
5. The battery charging indicator on
your unit appears and ChargePAK
will begin charging.
Note: When charging your ChargePAK for the first time or after an extended period of inactivity
it is recommended that it is charged for around 24 hours to ensure full battery power. If
ChargePAK is in a highly discharged state there may be a slight delay before the battery
charging indicator is displayed.
Removing ChargePAK
To remove your ChargePAK either to replace with normal batteries or install a new ChargePAK,
switch your product off, lift the ChargePAK out and pull gently on the connector plug to
remove it.
Note: Damage may occur if you attempt to remove the plug by pulling on the connecting wires
or ChargePAK itself.
Note: It is perfectly normal for your ChargePAK to get warm to the touch in use, especially
during charging. Your ChargePAK should give years of trouble-free use under normal
circumstances, however, as for all rechargeable batteries the operating life will gradually
reduce with age.