Sandvik Coromant Quick Change for CNC Lathes - Manual (Page 20)

20
C3
C4
C5
C6
C8
C10
32
40
50
63
80
100
22
27
35
45
55
68
40
50
60
65
80
110
Coromant Capto Short
Each machine has a maximum turret swing diameter. All
external tool projections need to be within this diameter
to allow the turret to rotate without collision. Turning
cutting units have a common length and offset dimen-
sion for each Coromant Capto size. The clamping units
for each machine turret interface are designed so that
the standard cutting units fit within the turret swing
diameter.
Note: external clamping units for revolvers are limited to maximum size C6
Tolerance on LF and WF is ±0.15mm
Using face milling holders on driven tools it is also
advised to keep the tool as short as possible. However
this is mainly for stability reasons rather than the swing
diameter. The bearings on a driven tool holder are much
closer together than a machining center. The short gauge
line reduces vibration allowing increased productivity with
increased security.
Coromant
Capto size
Flange dia
DCSFMS
Length
LF
Offset
WF