X Rockers 51437 User Manual

Page 3

Advertising
background image

READ BEFORE USAGE:

SET UP:

FUNCTIONS:

1
2.

3.
4.
6.
7.

8.
9.

X Rocker

is facing up

touching the floor

X Rocker

control panel

X Rocker

.

Lift the

out of the box

Keep the chair in the folded position and place it on the floor so that the back side of the chair is

and the

bottom of the seat

.

Review the set-up diagrams to familiarize yourself with the

s components, accessories, and set-up.

Pull and secure the velcro flap.
Unpack the power adapter, plug it into a power outlet and connect it to the power jack (A7) on the control panel.
Press the power button (A6) and confirm that the power indicator light (A1) is on. In wireless mode, turn on the power to the TX

box (A12), confirm that its indicator light is on, and check that the band selected on the TX box (A13) is the same as that selected
on the

(A3) of the X Rocker.

Follow the diagrams to connect the

to the audio source of your choice in wired or wireless mode.

Adjust the bass and volume levels to your preference

start rocking.

Foldable construction for ease of storage and portability.
Side control panel with volume, bass control, input/output jacks, and band switch.
Ergonomic design with full back support.
Easy to clean heavy duty upholstery grade vinyl cover.
Wireless audio transmission

Always make sure hinge is locked before moving.
Always make sure hinge is locked before sitting in the chair.
Excessive use of audio equipment could lead to hearing loss.
Excessive sound pressure from earphones and headphones can cause hearing loss.
Children under the age of 13 should not use this product without adult supervision.
Strictly for indoor use. Do not expose to direct sunlight, moisture or extreme temperatures.
If the cover becomes wet, disconnect the power immediately and don't use until it is completely dry.

When using in wireless mode connect the audio cable to the RX. Do NOT connect the audio input directly to the X Rocker
or the device will be DAMAGED.
The maximum input of the TX box is 1V. If the input is over 1V, the sound can become distorted or fuzzy. If the Sound
coming out of the chair is fuzzy at low volumes, lower the volume on the audio source (ex. The TV, Mp3,etc) and the
distortion should go away.
Do not mix alkaline, standard carbon-zinc, or rechargeable Ni-cad, NiMH, etc.
Do not mix old and new batteries.

Do not attempt to remove the cover or any components. Removal of the cover or tampering with components puts
you at risk for injury or death from electrical shock.

3

Need Help? Email: [email protected] Web: www.thexrocker.com
Phone:1 931 359 2603, In Europe, call +44 (0)845 468 0262

PICTURE OUT OF BOX

SITTING POSITION

Advertising