X Rockers 51324 - Manual (Page 7)

7
FUNCTIONS:
READ BEFORE USAGE:
PICTURE OUT OF BOX POSITIONING FOR VELCRO FLAP SITTING POSITION
SET UP:
Excessive use of audio equipment could lead to hearing loss.
Children under the age of 13 should not use this product without adult supervision.
Strictly for indoor use. Do not expose to direct sunlight, moisture or extreme temperatures.
If the cover becomes wet, disconnect the power immediately and don't use until it is completely dry.
Do not attempt to remove the cover or any components. Removal of the cover or tampering with components puts you
at risk for injury or death from electrical shock.
When using in wireless mode connect the audio cable to the RX. Do NOT connect the audio input directly to the V
or the device will be DAMAGED.
The maximum input of the TX box is 1V. If the input is over 1V, the sound can become distorted or fuzzy. If the Sound
coming out of the chair is fuzzy at low volumes, lower the volume on the audio source (ex. The TV, Mp3,etc) and the
distortion should go away.
Do not mix alkaline, standard carbon-zinc, or rechargeable Ni-cad, NiMH, etc.
Do not mix old and new batteries.
Always make sure velcro flap is attached before moving out.
Always make sure velcro flap is attached before sitting in the V Rocker .
Rocker
Lift the V Rocker out of the box by opening the top and turning the box over. DO NOT LET THE UNIT FALL OUT. Slide the box off
of the unit. Do not grab the sides of the V Rocker as that may lead to accidental speaker damage.
Keep the chair in the folded position and place it on the floor so that the back side of the chair is touching the floor and the
bottom of the seat is facing up.
Position the chair on the floor so that both the headrest and the foot of the seat are touching the floor. This is shown above in
the "POSITIONING FOR VELCRO FLAP" diagram.
Review the set-up diagrams to familiarize yourself with the V Rocker's components, accessories, and set-up.
Remove all of the included accessories from the accessory pack that is included with your chair.
Carefully turn the chair over.
Locate the input/output panel on the right side of the seat. When used in wired mode, make sure that the control panel is not
more than 9.84ft / 3 meters away from the audio source and 6.56ft / 2 meters away from a power source. When used in wireless
mode, make sure that the control panel is not more than 65.6ft / 20 meters from the audio source and 6.56ft / 2 meters from a
power source.
Unpack the power adapter, plug it into a power outlet and connect it to the power jack (A7) on the control panel.
Press the power button (A6) and confirm that the power indicator light (A1) is on. In wireless mode, turn on the power to the TX
box (A12), confirm that its indicator light is on, and check that the band selected on the TX box (A13) is the same as that selected
on the RX (A3) of the V Rocker.
Follow the diagrams to connect the V Rocker to the audio source of your choice in wired or wireless mode.
Adjust the bass and volume levels to your preference start rocking.
Attach the Velcro flap.
Foldable construction for ease of storage and portability.
Side control panel with volume, bass control, input/output jacks, and band switch.
Ergonomic design with full back support.
Easy to clean heavy duty upholstery grade vinyl cover.
Wireless audio transmission
Need Help? Email: [email protected] Web: www.xfunctional.com
Phone: 931 359 2603, In the UK, call +44(0)208 978 3707 or +44(0)208 978 3708