APC iSCSI SATA II - Manual (Page 80)

[80]
B. Event Notifications
š PD events
Level Type Description
INFO Disk inserted Disk <slot> is inserted into system.
WARNING Disk removed Disk <slot> is removed from system.
ERROR HDD failure Disk <slot> is disabled.
š HW events
Level Type Description
WARNING ECC error Single-bit ECC error is detected.
ERROR ECC error Multi-bit ECC error is detected.
INFO ECC info ECC memory is installed.
INFO ECC info Non-ECC memory is installed.
INFO SCSI info Received SCSI Bus Reset event at the
SCSI Bus <number>.
š EMS events
Level Type Description
INFO Power installed Power <number> is installed.
ERROR Power absent Power <number> is absent.
INFO Power work Power <number> is restored to work.
ERROR Power warning Power <number> is out of work.
WARNING Power detect PSU signal detection <number>.
INFO Fan work Fan <number> is restored to work.
ERROR Fan warning Fan <number> is out of work.
INFO Fan installed Fan <number> is installed.
ERROR Fan not
present Fan <number> is not present.
WARNING Thermal
warning
System temperature <location> is a little
bit higher.
ERROR Thermal critical System Overheated <location>!!!
ERROR Thermal critical
shutdown
System Overheated <location>!!! The
system will do the auto shutdown
immediately.
WARNING Thermal ignore
value
Unable to update thermal value on
<location>.
WARNING Voltage
warning
System voltage <location> is a little bit
higher/lower.
ERROR Voltage critical System voltages <location> failed!!!
ERROR Voltage critical
shutdown
System voltages <location> failed!!! The
system will do the auto shutdown
immediately.
INFO UPS info UPS detection succeeded.
WARNING UPS error UPS detection failed.
ERROR UPS error AC loss for the system is detected.
ERROR UPS error UPS Power Low!!! The system will do the