Audiovox Jensen Phase Linear UMP8015 - Manual (Page 4)

UMP8015
4
15
Antenna
Connector
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Accessory/Ignition
Connect to existing radio
wire or radio fuse.
Amplifier Wiring
Connect line out for
optional external
amplifiers. The red
connector is for the right
and the white connector is
for the left.
Gray
+
Blue
Black
Yellow
Red
White/Black (-)
White (+)
Gray/Black (-)
Gray (+)
Violet (+) Green (+)
Green/Black (-) Violet/Black (-)
LF/AVG RF/AVD
LR/ARG RR/ARD
CD Changer
Connector
0.5A
15
Fuses
When replacing a fuse,
make sure the new fuse is
the correct type and
amperage (15 amp ATO).
Using an incorrect fuse
could damage the radio.
Blue
Subwoofer Output
Connect to optional
subwoofer.
WIRING
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.