Vaisala WHP25 - Manual (Page 12)

User's Guide ________________________________________________________
10 _____________________________________________________ M210376en-A
0212-185
Figure 2 Mounting WHP25 Mains Power Supply on a
Pole Mast
The following numbers refer to Figure 2 above.
1 = Enclosure
2 = Slot screw M6, washer A6, spring washer B6, and
nut M6
3 = Mounting clamp
4 = Pole mast, diameter from 99 to 105 mm
5 = Cable gland
6 = Cable
3. If the local voltage level is other than 230 VAC,
reselect the voltage with the X2 and X3 jumpers
located inside the WHP25 unit. For the location of the
jumpers, refer to Figure 3 on page 11. For instructions
how to set the jumpers for different input voltages,
refer to Figure 4 on page 11.
WARNING Improper jumper setting damages WHP25 Mains Power
Supply.
CAUTION Observe the instructions and warnings in the instruction
label inside the unit, refer to Figure 4 on page 11.