HighPoint NA333TB - Manual (Page 3)

7. Unscrew the four screws on L-type bracket on plate drawer, place
the Mac mini Server into drawer, and restore the L-type bracket to
fasten Mac mini Server with drawer.
8. Connect NA381TB and Mac mini Server with Thunderbolt TM cable
9. Restore the top cover of NA381TB and immobilize the chassis on a
server rack or proper place.
10. Connect NA381TB with power source.
11. Take out the HDD trays.
12. Place the HDDs in the trays and fix them with hard drive mounting
screws. Put the trays with HDDs back to NA381TB.
1. When NA381TB is connected to the power source with two power
cords connecting to PSU of NA381TB, turn on the power switch of
PSU (turn the switch to “I” position to enable the power supply).
4. Verify the PCIe cards installed in NA381TB. After the verification of
HighPoint Thunderbolt TM target card, click PCI Cards on left side of the
pane, and then all the PCIe cards installed in NA381TB will be shown in
the information area in the pane. (For RAID controller card, from starting
up, it will take more time for its info to be displayed.)
3. Verify HighPoint Thunderbolt TM target card is recognized by Mac mini
Server. Click the Apple icon on top left of the screen, select About This
Mac , and then select More Info. Next, click System Report, and a pane
will pop up. Select Thunderbolt TM on left side of the pane, and if
NA381TB can be selected to see the information, then the HighPoint
Thunderbolt TM target card is recognized by Mac mini Server.
2. The NA381TB is designed to be powered on/off simultaneously with
Mac mini Server when NA381TB is connected to Mac mini Server by
Thunderbolt TM cable. Therefore, power on Mac mini Server first, and
then NA381TB will be powered on automatically. (NA381TB also
supports hot-plug and hot-unplug for powering-on and powering-off.)
• The following verification steps are for Mac OS X.
6. Operation and Verification
turn the switch to
position “ I ”
Mac mini Server
If you have any questions, please contact your regional
distributor, or HighPoint Technologies, Inc.
5. Verify that the drivers of RAID controller card and PCIe cards are
installed on OS X. When seeing all the PCIe cards listed from the last
step, there will be a column Driver Installed which indicates the status
of PCIe cards’ drivers. If it shows “No” in the status, then find and install
the Thunderbolt TM -aware driver of the PCIe card, and then the status
will become “Yes” to show the driver of the PCIe card has been
installed successfully.
6. After verifying that the driver of the RAID controller card is installed,
follow the operation procedure instructed by the manufacturer of the
RAID card to set up the RAID volume.
7. While NA381TB is connected to Mac mini Server by Thunderbolt TM
cable, when shutting down Mac mini Server, the NA381TB will be shut
down simultaneously as well.
Notice: The NA381TB chassis supports SGPIO. When any HDD fails, the red
LED indicator on that tray will light. The SGPIO function will be effective when
the SAS/SATA RAID card supports SGPIO function (for example, Areca’s RAID
controller card).
HighPoint Technologies, Inc.
Address: 1161 Cadillac Court, Milpitas, CA 95035
E-mail: [email protected]
Phone: (408) 240-6108 (Monday~ Friday, from 9am~6pm)
Skype: Highpoint.Thunderbolt
Support: www.highpoint-tech.com/websupport
TM