HighPoint RocketRAID 2224 - Manual (Page 52)

HighPoint Technologies, Inc.
Step 4 Configure the System to Mount Volumes at Startup
Instruct the system to automatically mount the array by modifying the file /etc/fstab.
Example: Add the following line to instruct the system to mount /dev/da1s1e to location /mnt/hpt after
startup:
/dev/da1s1e /mnt/hpt ufs rw 0 0
3 - Updating the Driver
To update the driver with a newer revision, simply reinstall the driver following the steps discussed in the
previous section, “Install the driver on an existing system”.
4 – Uninstalling the Driver
The driver can only be uninstalled when the system is not booting from devices attached to the RR2224
controller. To uninstall, remove the line hptmv6_load=”YES” located in /boot/defaults/loader.conf, and
then delete the driver module /modules/hptmv6.ko or /boot/kernel/hptmv6.ko.
48