HighPoint RocketRAID 1720 - Manual (Page 26)

RocketRAID 1720 Driver and Software Installation
4 -
windows asks to reboot the system, choose No.
5. Windows will then display a second “Found New Hardware Wizard” window –
repeat steps 1 through 4.
6. Remove the Driver Installation diskette from the floppy drive, then Shut down
and restart the computer.
Installation Verification
After the driver has been installed, and the system has been restarted:
1. Click the Start button, then right-click My Computer icon. Select the Properties
item from the popup menu.
2. In the popup window, select Hardware tab and then click Device Manager
button.
3. Double click the “SCSI and RAID controllers” entry. If the RocketRAID 1720
device entry is not displayed, or there are “?” or “!” marks displayed near the
RocketRAID 1720 entry, the driver has not been installed properly. Delete the
entries and reinstall the driver.
Installing the RocketRAID 1720 driver during a fresh Windows
2000/XP/2003/x64 installation
1. After booting from the Windows 2000/XP/2003 CD-ROM, when the Windows
Setup blue screen appears, look towards the bottom of the screen. Windows will
prompt you to press the F6 key if you want to install a third party SCSI or RAID
driver. Press the F6 key at this time.
2. The setup procedure will continue, and will later instruct you to press the “S” key
to specify additional adapters. Press the “S” key as instructed.
3. Next, the setup program will prompt for the insertion of the driver diskette. Please
insert the driver diskette, and then press ENTER to continue.
4. The next window will display several driver options. Please select the
RocketRAID 1720 Controller for the corresponding operating system, and press
ENTER to continue.
4