Bondioli&Pavesi 399CECN02_G - Manual (Page 12)

12
ENG
INSTALLATION
Always wear adequate safety equipment when performing any maintenance
or repair work.
The tractor stamped on the shield indicates the tractor end of the driveline.
Any torque limiter or overrunning clutch should always be installed on the
implement end.
Ensure that the driveline is securely attached to the tractor and the implement
before operating.
Check that all fixing screws are tight.
Attach the driveline guard restraints (chains). Best results are achieved when
chains are attached nearly perpendicular to the driveline guard. Adjust the
length of the chains to allow enough slack for full movement of the driveline during
turns, operation, and transport. Avoid excessive slack, which could cause the
chains to roll around the driveline.
Never use the safety chains to transport or support the driveline when you
have finished using it for storage. Always use the support provided on the
implement.
Clean and grease the tractor PTO and implement shaft before installing the
driveline.
Keep the driveline horizontal during handling to prevent the halves from
sliding apart, which could cause injury or damage the shielding. Use suitable
means to transport heavy drivelines.
Check that all components are in good condition and properly lubricated
before using the driveline. Clean and re-lubricate the driveline before storage
at the end of the season. Lubricate the parts according to the diagram; lubrication
intervals are in expressed in hours.
Pump grease into the crosses until it purges from the bearing caps.
Inject the grease gradually and avoid pumping the grease gun violently with
resulting high delivery pressure.
Use NLGI grade 2 grease.
BALL COLLAR
Align the yoke on the PTO. Slide the collar to the open position. Slide the
yoke onto the splined shaft. Release the collar and pull or push the yoke along the
shaft until the balls engage the groove and the collar returns to its original (closed)
position. Make sure the collar returns to its initial (closed) position and the yoke is
properly attached to the shaft.
SHEAR PINS
Use only bolts of the size and class shown in the implement handbook.
Choose the bolt length in such a way as to minimize protrusion.
Replace worn or damaged parts with genuine Bondioli & Pavesi spare parts.
Do not modify or tamper with any part of the driveline. For any operations not
explained in this instruction manual, consult your implement dealer or manufacturer,
or your local Bondioli & Pavesi representative.
15
16
17
18
19
20
21
23
24
25
22