Ronbow Motion Sensor LED Light - Manual (Page 4)

RONBOW CORP INSTALLATION GUIDE ronbow.com
INSTALLATION SHEET
MOTION SENSOR LED LIGHT
ACCESSORIES MODEL: 710024-NF
710030-NF
StEp 1: Remove the wall plug section from the
wire by cutting the wire.
See Figure 1.
Note: Recommend licensed electrician. A low volt-
age transformer will be required.
figure 1.
HARDWARE INSTALLATION
Cut at dotted line
StEp 2: Using wire snippers, remove a portion of
the plastic cover to reveal the wires.
See Figure 2.
Note: Positive (with writing)
Negative (without writing)
Cut at dotted line
StEp 3: Connect the positive and negative from
the house wires to the power adapter cord.
See Figure 3.
+ -
figure 2.
figure 3.
MAtERIALS nEEDED:
SCREWDRIvER
WIRE MOLDINg OR WIRE StApLES
WIRE SNIppERS (OptIONAL)
WIRE NutS (OptIONAL)
LOW vOLtAgE tRANSFORMER (OptIONAL)
MAtERIAL pRoVIDED:
(2) BRACkEtS
(3) SCREWS
House
wire
power
adapter
wire
House
wire
power
adapter
wire