Red Lion MDC User Manual
Page 29
FACTORY SETTINGS
MASTER MODE:
FOLLOWER MODE:
USER SETPOINTS:
USER SETPOINTS:
S1
500
S1
1.0000
S2
1000
S2
0.5000
R1
100
R1
0.1000
R2
200
R2
0.2000
DISPLAY 1
DISPLAY 1
LINE 1
SPD-MNE
LINE 1
SPD-MNE
LINE 2
SPD-VAL
LINE 2
SPD-VAL
DISPLAY 2
DISPLAY 2
LINE 1
OP STAT
LINE 1
OP-STAT
LINE 2
SPD- VAL
LINE 2
SPD-VAL
DISPLAY 3
DISPLAY 3
LINE 1
AL STAT
LINE 1
LDHZ-VAL
LINE 2
SPD -VAL
LINE 2
FBHZ-VAL
DISPLAY 4
DISPLAY 4
LINE 1
TRIM-VAL
LINE 1
TRIM-VAL
LINE 2
SPD -VAL
LINE 2
SPD-VAL
SCALING:
PPR LD
60
MAX RPM LD
1750
-27-
USER SETTINGS
This Menu should only be entered if the operator wants to reset ALL
parameters in either Master or Follower mode to the factory settings. If the
MDC is in Master Mode when the word “FACTORY” is flashing in the
display and the ENT key is pressed, all parameters for that mode are reset to
the factory settings upon exiting the Programming Module. The same is true
for Follower Mode. Parameters common to both Master and Follower modes
are reset regardless of the operating mode. The operator can exit the factory
settings option WITHOUT resetting all parameters by pressing the <ESC
key. The following are the settings when shipped from the factory, along with
a chart for user settings:
Caution: If factory settings are selected, all programming by the user for that
operating mode will be reset.
FACTORY SETTINGS COMMON TO MASTER AND FOLLOWER MODES:
USER SETPOINTS:
OPTIONS:
JOG SPD
200
Operator Access:
JOG RAMP
50
S1
YES
AL-1
1200
S2
YES
AL-2
100
R1
YES
GAIN
99
R2
YES
JOG SPD
YES
SCALING:
JOG RAMP
YES
PPR FB
60
AL-1
YES
MAX RPM FB
1750
AL-2
YES
DSP DP
0
GAIN
YES
DSP UNIT
1750
SPT SCROLL
YES
USER INPUTS:
No Feedback Detection:
YES
User Input 1
NO MODE
User Input 2
NO MODE
User Input 3
NO MODE
User Input 4
NO MODE
User Key F1
RUN
User Key F2
R-STOP
ALARM OUTPUTS:
ALARM 1:
Alarm Type
HIGH ALM
Phase
+ PHASE
Latched/Boundary
BOUNDARY
Update
NORM UPD
ALARM 2:
Alarm Type
LOW ALM
Phase
+ PHASE
Latched/Boundary
BOUNDARY
Update
NORM UPD
Stop Mode Status
STP DSBL
DISPLAY:
Scroll Speed
NONE