Red Lion BMK8 - Manual

INSTALLATION
1. Mark and drill holes (5/32") in existing panel using the
BMK8 as a template. An addition hole may be cut in
the existing panel for wire feed.
2. Remove the panel latch (mounting clip) from the
CUB7 unit and insert the mounting screws (supplied
with the CUB7) on both sides of panel latch. The tip
of the screw should not project from the hole in the
panel latch (mounting clip).
3. Slide the CUB7 through the cut out in the BMK8 until the
bezel flange contacts the base mount. The CUB7 panel gasket
is optional.
4. Slide the panel latch (mounting clip) over the rear of the unit and
towards the front of the unit until it latches firmly against the inside of the
base mount. Note: It is necessary to hold the CUB7 in place when sliding the
mounting clip into position.
5. Alternately tighten mounting screws.
6. Route wires through existing panel wire hole or through wire hole on base mount
and connect to the appropriate terminals on the CUB7.
7. Mount the CUB7/base mount assembly to the existing panel or frame utilizing
the four bolts and nuts provided with the base mount.
DESCRIPTION
The BMK8 base mount is designed for use with the CUB7 series products.
Wire feed to the CUB7 unit may be through the existing panel/frame or through
the hole in the BMK8 itself.
The base mount is constructed of steel with a textured black finish and
includes four mounting bolts and nuts.
MODEL BMK8 - BASE MOUNT KIT FOR CUB7
DIMENSIONS In inches (mm)
Bulletin No. BMK8-X
Drawing No. LP0579
Effective 4/05
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
For More information on Pricing, Enclosures & Panel Mount Kits refer to
the RLC Catalog or contact your local RLC Distributor.
BMK80000 CUB7 BASE MOUNT KIT BMK8
PART NUMBER DESCRIPTION MODEL NO.
ORDERING INFORMATION