ARI Armaturen STOBU PN63-160 EN - Manual (Page 7)

Operating and installation instructions
STOBU
®
PN63-160
Rev. 0040102002 0213 Page 2-7
4.4 Technical data - remarks
for
- Principal dimensions
- Pressure-temperature-ratings
- Valves with butt weld ends, etc. refer to datasheet.
4.5 Marking
5.0 Installation
5.1 General notes on installation
The following points should be taken into account besides the general principles governing
installation work:
fig. 9
Address of manufacturer: refer to item 11.0 Warranty / Guarantee
According to the Pressure Equipment Directive table 6, annex II, valves without safety
function are only allowed to bear the CE-marking DN32 onwards.
ATTENTION !
- Remove flange covers if present.
- The interior of valve and pipeline must be free from foreign particles.
- Note installation position with reference to flow, see mark on valve.
- Steam line systems should be designed to prevent water accumulation.
Type number
Serial number
Manufacturer
CE-marking
Aprpoval
(No./inspector/year)
Year of manufacture
(clear speach)
PSmax (max. allowed pressure)
PS (operating pressure) Body material
TS (operating temperature)
TSmax. (max. allowed temperature)
Notified body
Plug design