AMETEK 955 eBrik - Manual (Page 5)

For customer service or technical support
call Toll Free 800-635-0289
Specifications
General Specifications
Connector 5-pin 12mm Euro Micro
Displacement 1” to 72” in 1” Increments
Electrical Specifications
Input Voltage 24 VDC ±20%
Current Draw 1.1W (44mA typical)
Dead Band 2.75”
Null Zone 2.75”
Non-linearity less than ± 0.03% of stroke or ± 0.013”, whichever is greater
Repeatability 0.001%
Hysteresis less than 0.001”
Operating Temperature: -40ºC to 85ºC
Analog Output Specifications
Voltage Output Minimum Load Resistance
Output Current 2K Ohms
Guaranteed 5mA minimum for voltage units
Analog Ripple 1 mV maximum
Current Output Maximum Load Resistance 500 Ohms
Update Time
1ms
Resolution
Internal .00006”
Output 16-bit
Output Type
Voltage Output 0V to 10V, 10V to 0V
Current Output 4mA to 20mA, 20mA to 4mA
Enclosure Rating - IP-67
Approvals - CE (EMC)
Note: Specifications are based on a 48” stroke with floating magnet SD0551500 and 1/8” gap.
AMETEK Automation & Process Technologies has checked the accuracy of this manual at the time it was approved for printing. However, this manual
may not provide all possible ways of installing and maintaining the LDT. Any errors found in this manual or additional possibilities to the installation and
maintenance of he LDT will be added in subsequent editions. Any comments you have for the improvement of this manual are welcomed. AMETEK
reserves the right to revise and redistribute the entire contents or selected pages of this manual. All rights to the contents of this manual are reserved by
AMETEK.
Options
X = No Options
P= Programmable Zero and Span
Output
V0 = 0 to 10
V1 = 10 to 0
C2 = 20 to 4mA
C4 = 4 to 20mA
Stroke Length
Insert stroke length to 1 inch or
25mm. Enter as a four-place number.
Example: 12.0 inch stroke is entered
as 0120 (E) or 100mm is entered as
0100 (M).
Units of Measure
E = English US Inches / M = Metric
Magnet Type
FM = Floating Magnet (Standard)
SM = Slide Magnet Top Swivel
SF = Slide Magnet Front Swivel
X = No Magnet
955 eBrik™
955e V0 0120 E FM X
Part Numbering Accessories
Item Part Number
Slide Magnet SD0521800
Large Float Magnet SD0551500
Mounting Foot SD0522000
6 Ft, 5 Pin Straight Cable 949019L6
12 Ft, 5 Pin Straight Cable 949019L12
6 Ft, 5 Pin Right Angle Cable 949020L6
12 Ft, 5 Pin Right Angle Cable 949020L12