AMETEK 955S Smart Brik LDT User Manual
Page 5
5
1080 N. Crooks Road • Clawson, MI 48017 • 800.635.0289 • 248.435.0700 • Fax 248.435.8120 • www.AMETEKAPT.com
Mounting brackets (SD0522000) slide in the grooves
on the side of the extruded housing. When tightened
down with fastening hardware the mounting brackets
clamp the unit into place. It is recommended to use
one mounting bracket on each end and every three
feet between.
A standard female swivel mounting arm is
provided with the slide magnet assembly.
For extensions and other options contact the
factory.
A standard 12 mm 4 pin micro connector is used. Straight mating cables can
be ordered in a 6’ length, or 12’ length. If space is a consideration a right angle
connector is also available.
WARNING
Do not use cord sets with LED’s
.25
OF MAGNET SLUG
Sensing Surface
N
S
Floating Magnet Assembly (SD0522100)
NOTE 1: The north pole of the magnet should be
pointed towards the probe.
NOTE 2: If using the Floating Magnet Assembly option,
you must set Automatic Gain Control. See page 3.
Dimensions
CL