VariZoom VZFP - Manual (Page 7)

7
VZ-FPB
Balancing/Docking Plate for the FlowPod
The VZ-FPB consists of the mounting plate and c-clamp
Using the VZ-FPB is simple. The FlowPod grip handle has a machined
groove near its top that enables you to slip the handle into the u-shaped
slot of the VZ-FPB plate, securing the FlowPod for the balancing
procedure.
First you must secure the FPB to a sturdy, flat, level surface (e.g., table
or workbench) with the supplied clamp. Note that the top of the plate has
a recessed circle to accommodate the fixed contact pad of the c-clamp. See
the picture above.
Once you have secured the FPB, slide the FlowPod handle into the u-
shaped slot of the plate. The handle should drop into the sunken round
section at the back of the slot, locking the FlowPod into position. Make sure
your FlowPod handle is unlocked and adjust the X-Y assembly so the
camera becomes level (horizontal balance).
For vertical balancing, the FPB is a good place to attach and adjust your
weights. You can do the ‘drop test’ from the FPB, but the range of motion
will be limited and you should exercise caution so neither FlowPod nor
camera strike the table. For final testing, you’ll need to be holding the
FlowPod to check the side-to-side stability, so plan on approximating the
vertical balance on the FPB and doing the final tweak after the handheld
test.
You may find that you’ll want to tweak the overall balance after handling the
unit for a few minutes. Although the simple guidelines in the instructions
explain how to balance the unit, the art of balancing the FlowPod is really in
acquiring a feel for correct balance. After balancing your camera properly
one time, it’s a simple matter to do it again.
The FPB is a major help in balancing, but it will also provide a docking stand
to hold the FlowPod while you’re not using it.
www.varizoom.com