VariZoom VZCROSSFIRE-FP - Manual (Page 4)

4
B) Lite Mode (w/o tripod): Cameras under 5 lbs can also be used in lite mode by removing the
tripod entirely. As equipped, the lite mode will work with cameras up to about 1.8 lbs. The added
advantage of the Lite Mode is that when the stabilizer isn’t being used, it can be docked on the
tripod portion. To use the lite mode with heavier cameras, purchase the deluxe counterweight kit
(VZ-XFFP-WK).
5. Horizontal Balance - Adjust the X-Y assembly (pictured below) so your camera’s mass is
centered on the pan axis (the centerline of the CrossFire FP gimbal). Loosen the locking lever on
the side & round thumbscrews underneath, then adjust the X-Y assembly front-to-back and side-
to-side until the camera is level, then tighten the lever & thumbscrews.
6. Vertical Balance - Now you can check the vertical balance of the CrossFire FP to see if you need
to add, remove, or adjust the position of the counterweights. Use as few weights as possible, and
start with the weights at the top of the shaft. When vertically balanced, the CrossFire FP should
not lean or sway when moved around.