Videoswitch Vi-MPEG4 - Manual (Page 3)

MPEG4 Streaming Module
1
1 Hardware Setup
• Connect the ViX05 DVR to a router, hub or switch using a CAT5 cable
• Connect the Vi-MPEG4 module to the same router, hub or switch using a CAT5 cable
• Connect the Vi-MPEG4 module to the main monitor output of the DVR using a BNC cable.
• Power up the ViX05
• Connect the Vi-MPEG4 module to supplied power adaptor (12V regulated)
2 Vi-MPEG4 IP Module Configuration
The Vix05 and MPEG4 module require consecutive IP addresses. The default values are:
ViX05 192.168.1.50
MPEG4 192.168.1.51
If you need to change the default IP address of the Vi-MPEG4 module, download the utility “Vi-MPEG4 Finder.exe”
from the Videoswitch web site (www.videswitch.co.uk/software) . Double click on the downloaded file (Vi-MPEG4
Finder.exe) and follow these steps to locate and configure the MPEG4 module:
Step 1:
Press Search to locate the module on the network. If no module is found, you may need to
temporarily disable your PC’s firewall.
Step 2: Click on the Device Name to select the module.
Step 3: Enter the required IP address for the module, the subnet mask and the ip address of the default
gateway.
Step 4: Click on Submit to configure the module.
Step 4
Step 1
Step 3
Step 2