Videoswitch VM - Manual (Page 18)

VM-Series Multiplexer User Manual 20/02/2002 12:00
Videoswitch
18 VM601h.doc
Camera Termination The 75 Ohm camera terminations may be individually
turned on or off here. Use
п р с т SELECT.
Press BACK to finish.
Camera Brightness
Camera 1,2,3 etc Select the required camera using с т, then press
ENTER to continue or BACK to finish.
Digital Full/Multi/Record The input gain may be varied to adjust the brightness
of the digital full screen, the multip-screens and the
recorded images. It is preferable to leave at the
default setting and to ensure that the camera is
properly adjusted. Use
п р and BACK to finish.
Analogue Full Screen The brightness of the analogue full-screen images
may be adjusted here. It is preferable to leave at the
default setting and to ensure that the camera is
properly adjusted. Use
п р and BACK to finish.
Playback Brightness The playback gain may be varied to adjust the
playback brightness. Use
п р and BACK to finish.
Remote Keyboard
Address of this Multiplexer If several multiplexers are to be controlled by a single
remote keyboard, they must be assigned different
addresses. Use
с т. Press BACK to finish.
Interface Type A remote keyboard uses RS485. Computer control
will probably use RS232. Use
с т. Press BACK to
finish.
Test Mode When ON, communication errors will be displayed on
the main monitor. This is useful for testing remote
control by non-Videoswitch equipment. Use
с т.
Press BACK to finish.
Colour/Greyscale Test Bars Colour or Greyscale test bars may be set here for
testing or adjusting monitors etc.
Factory Defaults
Restore Factory Defaults This allows you to set all options in the multiplexer to
the factory defaults. Note that camera titles and
passwords are not cleared. Use
с т. Press BACK
to finish.
Reset Camera Titles This allows you to reset all the camera titles to
“Camera1”, “Camera2” etc. Use
с т. Press BACK
to finish.
Change Installer Password The installer password may be set here. Set to
“000000” if you want to allow free access. Use
п р с т and SELECT. Press BACK to finish.